print | close

The New QTS Engineering, Inc. Method


Our frame with a stencil on itSimply mount the stainless steel foil in the laser machining system. Cut out the customer’s aperture pattern, as well as the QTS Engineering, Inc. mounting pattern on the outside of the foil. Then mount the foil into the plastic Container Frame border (quick and easy) which QTS Engineering, Inc. has supplied to the stencil manufacturer. They ship the foil and border frame to you, the customer, and you simply mount the product in a Wizard frame that you’ve purchased from us, and tension it. Mounting and tensioning takes less than a minute, and you’re ready to print!
When you’re done with that production job, the inexpensive plastic boarder can be discarded and the stainless foil recycled. If the job will run again, the foil and plastic container frame can be easily cleaned and stored for future use.

Circuit boards, one unpopulated and one populated.The QTS Engineering, Inc. Wizard method saves setup time, shipping and material costs, storage space, and more. Best of all, it allows you, the customer, a greater level of control over your own stencils and process control settings (i.e., tensioning). More control and lower costs mean a better process, higher yields, and a better bottom line.

 

 

 

Change out a stencil and mount and tension a new one in less than a minute – in just a few simple, easy steps!

close